TIMING BELT AND MAINTENANCE WARING INDICATOR TOYOTA

Timing Belt Warning Indicator Reset Procedure all Toyota

T-BELT

1. T-BELT MODE DISPLAY

a) With ignition turned ON, using the trip switch (select/reset button) change the display to ODO, and turn the ignition OFF
b) While pressing the trip switch, turn the ignition switch ON and hold it for 5 seconds.
c) Release the trip switch, then press the switch again within 5 seconds.
d) The digital display should change to T-belt mode. The initial display "15" (0,000km) is displayed (ie. 150,000km).
2. REWRITING REPLACEMENT VALUES

While in the T-Belt mode, each press of the trip switch will change the displayed value by 10,000km increments. Once " 20 " (200,000km) is reached the display reverts back to " 1 " (10,000km) again. Remember, this setting is the number of kilometres to be travelled before the light comes on next, and once reset this counter will start from zero.
I believe the timing belt interval for all the 100/200 series engine variants is 150,000km, but this should be checked against each different markets servicing recommendation. This being the case, you shouldn't need to change from the default setting of "15".
Obviously for the US, the ODO is in miles, and I guess the T-Belt warning would be set in 10,000 mile intervals.
3. T-BELT WARNING RESET COMPLETION
a) After setting the replacement setting value, hold the trip switch ON for more than 5 seconds then release the switch.
b) Check that the display has now changed back to ODO and that the warning light has gone off when the engine is started.
NOTE: If the T-Belt mode is completed, even though the belt replacement has not been performed, the T-Belt warning IS reset.



MAINTENANCE WARING INDICATOR TOYOTA

Put the key in the ignition and turn it up one notch. The dashboard lights will not turn on
Press the button next to the odometer to get it to Trip A (different models require either the ODO, Trip A or Trip B, so try all if Trip A doesnt work)
Hold down your trip meter button next to the odometer
When you are holding the trip meter button down, turn your key to the next notch. So, the dashboard lights will be on, but the car will not be started. Do not start the car.
The spanner shaped light flashes irregularly a few times
Continue holding the trip meter button for about 10-15 seconds or until the spanner light turns off. You have now reset your Maintenance Required light.
Previous
Next Post »

Search This Blog

Translate

Popular Posts